wsm RTV-X1120D Workshop Manual page 141

RTV-X900, RTV-X1120D, WSM
Draining Engine Oil
WARNING
To avoid personal injury:
• Be sure to stop the engine before changing the oil.
• Allow engine to cool down sufficiently, oil can be not and
can burn.
1. Park the vehicle on a level surface.
2. Raise the cargo bed and mount the safety support.
3. Stop the engine.
4. Remove the rear skid plate (3).
5. To drain the used oil, remove the drain plug (4) at the bottom of
the engine and completely drain the oil into an oil pan.
All the used oil can be drained out easily when the engine is still
warm.
6. After draining, reinstall the drain plug.
(When reassembling)
• Fill the new oil up to the upper notch on the dipstick.
[RTV-X900]
Engine oil Capacity
[RTV-X1120D]
Engine oil Capacity
(1) Oil Inlet
(2) Dipstick
(3) Rear Skid Plate
(4) Drain Plug
Rear Wheel
1. Jack up the rear end after placing a wooden block under the
bottom plate of the transmission frame.
2. Remove the rear wheels.
(When reassembling)
Rear aluminum wheel
mounting bolt
Tightening torque
Rear steel wheel mounting
bolt and nut
(1) Rear Wheel
1-S32
ENGINE
[Filter exchanged]
3.1 L
3.3 U.S.qts
2.7 Imp.qts
[Filter non-exchanged]
2.7 L
2.9 U.S.qts
2.4 Imp.qts
[Filter exchanged]
4.1 L
4.3 U.S.qts
3.6 Imp.qts
[Filter non-exchanged]
3.8 L
4.0 U.S.qts
3.3 Imp.qts
[A] RTV-X900
[B] RTV-X1120D
C: Oil level is acceptable within this
range.
9Y1210946ENS0028US0
90 to 110 N·m
9.2 to 11.2 kgf·m
66.4 to 81.1 lbf·ft
108 to 130 N·m
11.1 to 13.2 kgf·m
79.7 to 95.8 lbf·ft
9Y1210946ENS0029US0
KiSC issued 01, 2014 A