wsm RTV-X1120D Workshop Manual page 160

RTV-X900, RTV-X1120D, WSM
Fan Drive Pulley
1. Secure the flywheel to keep it from turning.
2. Remove the fan drive pulley screw.
3. Draw out the fan drive pulley with a puller.
(When reassembling)
• Install the pulley to crankshaft, aligning the mark (1) on them.
• Apply engine oil to the fan drive pulley retaining screw. And
tighten it.
Tightening torque Fan drive pulley screw
(1) Alignment Mark
Gear Case
1. Disconnect the start spring (2) from the fork lever 1 (3).
2. Remove the screw (1) of inside the gear case and outside
screws.
3. Remove the gear case (4).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
sides of the gear case gasket.
• Be sure to set three O-rings inside the gear case.
(1) Screw (Inside)
(2) Start Spring
1-S51
ENGINE
118 to 127 N·m
12.0 to 13.0 kgf·m
86.8 to 94.0 lbf·ft
9Y1210946ENS0065US0
(3) Fork Lever 1
(4) Gear Case
9Y1210946ENS0066US0
KiSC issued 01, 2014 A