wsm RTV-X1120D Workshop Manual page 185

RTV-X900, RTV-X1120D, WSM
Idle Gear Side Clearance
1. Set a dial indicator with its tip on the idle gear.
2. Measure the side clearance by moving the idle gear to the front
and rear.
3. If the measurement exceeds the allowable limit, replace the idle
gear collar.
Factory specification
Idle gear side clearance
Allowable limit
Camshaft Side Clearance
1. Set a dial indicator with its tip on the camshaft.
2. Measure the side clearance by moving the cam gear to the font
and rear.
3. If the measurement exceeds the allowable limit, replace the
camshaft stopper.
Factory specification
Camshaft side clearance
Allowable limit
Camshaft Alignment
1. Support the camshaft with V blocks on the surface plate at both
end journals.
2. Set a dial indicator with its tip on the intermediate journal.
3. Measure the camshaft alignment.
4. If the measurement exceeds the allowable limit, replace the
camshaft.
Camshaft alignment Allowable limit
Cam Height
1. Measure the height of the cam at its highest point with an
outside micrometer.
2. If the measurement is less than the allowable limit, replace the
camshaft.
Intake
Cam height and
Exhaust
1-S76
ENGINE
0.20 to 0.51 mm
0.0079 to 0.020 in.
0.80 mm
0.031 in.
9Y1210946ENS0081US0
0.15 to 0.31 mm
0.0059 to 0.012 in.
0.50 mm
0.020 in.
9Y1210946ENS0115US0
0.01 mm
0.0004 in.
9Y1210946ENS0116US0
Factory
26.88 mm
specifica-
1.058 in.
tion
Allowable 26.83 mm
limit 1.056 in.
9Y1210946ENS0117US0
KiSC issued 01, 2014 A