Changing Operation Panel Display - Toshiba VF-S15 Instruction Manual

5.10 Changing operation panel display

5.10.1 Changing the unit (A/V) from a percentage of current
f701 :Current/voltage unit selection
Current 100% = Rated current of inverter
Voltage 100% = 200Vac (240V class), 400Vac (500V class)
 Example of setting
During the operation of the VFS15-2015PM-W (rated current: 8.0A) at the rated load (100% load), units are
displayed as follows:
1) Display in percentage terms
[Parameter setting]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
and voltage
 Function
These parameters are used to change the unit of monitor display.
%  A (ampere)/V (volt)
%
  Output current:
100%
%
  Input voltage:
100%
Title Function
Current/voltage unit
f701
selection
The f701 converts the following parameter settings:
*
 A display : Current monitor display: Load current, torque current
Motor electronic-thermal protection level 1 & 2
DC braking current
Stall prevention level 1 & 2
Small current detection current
Brake releasing small current detection level
 V display : Voltage monitor display: Input voltage, output voltage
V/f 5-point setting VF1-5 voltage
Note) Base frequency voltage 1 & 2(, ) always displayed in the unit of V.
2) Display in amperes/volts
 Output current:
8.0A
 Input voltage:
200V
Adjustment range
0: %
1: A (ampere) / V (volt)
, f173
f251
f601, f185
f611
f326
f191, f193, f195, f197, f199
E-23
E6581611
5
Default setting
0