Changing The Initial Display Of The Panel; Initial Panel Display Selection; Initial Extension Panel Display Selection; Changing The Display Format While Power Is On - Toshiba TOSVERT VF-nC3E Instruction Manual

6.20.5 Changing the initial display of the panel

 : Initial panel display selection
 : Initial extension panel display selection
 Function
This parameter specifies display format while power is ON.
 Changing the display format while power is ON
When the power is ON, the standard monitor mode displays the operation frequency (default setting) in the
format of "" or "". This format can be changed to any other monitor display format by setting
. This new format, however, will not display an assigned prefix such as  or . When the power is
ON, the display of the extension panel is set at .
★ When the power is ON, the main panel and the extension panel can be set to display differently.
[Parameter setting]
Title

Initial panel display selection


Initial extension panel display

selection
★  For details on / =, see the Communications Function Instruction Manual.
6.20.6 Changing display of the status monitor
 -  : Status monitor 1 to 6
Change monitor display items in the status monitor mode.
 Refer to chapter 8 for details.
6.20.7 Integrating wattmeter
f749 : Integrating wattmeter display unit selection
 Functio n
At the main power off, this monitor value is cleared and also, the display unit is selec table.
Title
Integrating wattmeter display unit selection
f749
Function
0: Operation frequency (Hz/free unit)
1: Output current (%/A)
2: Frequency setting value (Hz/free unit)
3 to 17: -
18: Arbitrary code from communication
Function
F-67
Adjustment range
Adjustment range
0:1=1kWh
1:1=10kWh
2:1=100kWh
3:1=1000kWh
E6582233
Default setting
6
0
0
Default setting
Depends on
the capacity
(Refer to
section 10.4)