Installation Environment - Toshiba VF-S15 Instruction Manual

Remedies:
1.4.4
 Installation environment
This inverter is an electronic control instrument. Take full consideration to installing it in the proper operating
environment.
Prohibited
Mandatory
action
Prohibited
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
motor's magnetic noise. The setting of PWM carrier frequency is done with the parameter f300
(Refer to section 6.18).
1. Use a meter output terminal in the inverter control circuit.
The load current can be output on the meter output terminal (FM). If the meter is connected, use an
ammeter of 1mAdc full scale or a voltmeter of 10V full scale.
0-20mAdc (4-20mAdc) can be also output. (Refer to section 5.1)
2. Use the monitor functions built into the inverter.
Use the monitor functions on the panel built into the inverter to check current values. (Refer to
section 8.2.1)
Installation
 Do not place any inflammable substances near the inverter.
If an accident occurs in which flame is emitted, this could lead to fire.
 Do not install in any location where the inverter could come into contact with water or other fluids.
This can result in electric shock or fire.
 Operate under the environmental conditions prescribed in the instruction manual.
Operations under any other conditions can result in malfunction.
 Check to make sure that the input power voltage is +10%, -15% of the rated power voltage (±10%
when the load is 100% in continuous operation) written on the name plate.
If the input power voltage is not +10%, -15% of the rated power voltage (±10% when the load is 100%
in continuous operation), this can result in fire.
 Do not install the inverter in any location subject to large amounts of vibration.
This could cause the unit to fall, resulting in bodily injury.
Warning
Caution
A-29
E6581611
1