Toshiba VF-S15 Instruction Manual page 233

[Parameter setting]
f669
f676
f677 
f678  Pulse train output filter
●
Note 1: When item of f676 reaches "Reference of max. value", the number of pulse train set by f677
Note 2: The ON pulse width is maintained constant.
Note 3: The minimum pulse output rate is 10pps. Keep in mind that no pulses can be put out at any rate
Note 4: f676 = 12 is the motor drive frequency.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Title Function
Logic output/pulse train
output selection (OUT)
Pulse train output function
selection (OUT)
Maximum numbers of
pulse train output
Digital panel meter for reference
Type: K3MA-F (OMRON)
Connection terminal: OUT-E4, NO-E5
are sent to output terminals (OUT)
The ON pulse width is fixed at a width that causes the duty to reach 50% at the maximum pulse
number set with f677 .
Therefore, the duty is variable.
For example, the ON pulse width is
smaller than this.
Adjustment range
0: Logic output
1: Pulse train output
0: Output frequency
1: Output current
2: Frequency command value
3: Input voltage (DC detection)
4: Output voltage (command value)
5: Input power
6: Output power
7: Torque
8: -
9: Motor cumulative load factor
10: Inverter cumulative load factor
11: PBR (Braking resistor) cumulative
load factor
12: Stator frequency
13: VIA input value
14: VIB input value
15: Fixed output 1
(output current 100% equivalent)
16: Fixed output 2
(output current 50% equivalent)
17: Fixed output 3
(Other than the output current)
18: Communication data
19: -
20: VIC input value
21, 22: -
23: PID feedback value
0.50-2.00 (kpps)
2-1000 (ms)
approximately 0.6 ms when f677 = 0.80 (pps)
approximately 0.5 ms when f677 = 1.00 (pps)
approximately 0.3 ms when f677 = 1.60 (pps)
F-121
E6581611
Reference
Default
of maximum
setting
value of
f677
– 0
fh 
185%
fh 
150%
150%
185%
185%
250%
-
100%
100%
100%
fh 
0
10 V
10 V
6
185%
185%
100%
100.0%
-
20mA
-
100%
– 0.80
–
64