Selection Of Operation Mode - Toshiba VF-S15 Instruction Manual

6.2

Selection of operation mode

6.2.1 Selection of start/stop and frequency settings
cmod : Command mode selection
fmod : Frequency setting mode selection
 Function
These parameters are used to specify which input device (panel keypad, terminal block, or
communication) takes priority in entering an operation stop command or frequency setting mode (terminal
VIA/VIB/VIC, setting dial, communication, or UP/DOWN from external logic).
<Command mode selection>
[Parameter setting]
Title

6
[Programmed value]
:
:
:
3:
4:
* Operation command selected by  and the operation commands from the terminal block can be
switched alternately with ON/ OFF of input terminal. (input terminal function number 108, 109) See the table of
input terminal function selection in section 11.6.
* When priority is given to commands from a linked computer or terminal block, they have priority over the
setting of .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Function
Command mode selection
Terminal block
ON and OFF of an external signal run and stop operation.
operation
Panel keypad Press the
operation
Operation can also be done from the extension panel.
RS485 Run/stop operations by RS485 communication from an external device.
communication
 Refer to section 6.38.
CANopen Run/stop operations by CANopen communication from an external device.
communication
 Refer to "CANopen communication Instruction Manual E6581911".
Communication Run/stop operations by commands from a communication option.
option
 Refer to each Instruction Manual of option.
Adjustment range
0: Terminal block
1: Panel keypad (including extension panel)
2: RS485 communication
3: CANopen communication
4: Communication option
and keys on the panel keypad to run and stop.
RUN
STOP
F-12
E6581611
Default setting
1