Description Of Terminals - Toshiba VF-S15 Instruction Manual

2.3

Description of terminals

2.3.1
 Connections with peripheral equipment
2
Power
supply
Note 1: The T/L3 terminal is not provided for any single-phase models. So if you are using single-phase
 Power circuit
Terminal symbol
R/L1,S/L2,T/L3
U/T1,V/T2,W/T3
PA/+, PB
PA/+
PC/-
PO, PA/+
The arrangements of power circuit terminals are different from each range.
Refer to section 1.3.3.1) for details.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Power circuit terminals
Molded-case Magnetic
Input AC
noise
contactor
circuit braker reactor
reduction filter
models, use the R/L1 and S/L2/N terminals to connect power cables.
Grounding terminal for connecting inverter. There are 3 terminals in cooling fin or
mounting part of EMC plate.
240V class : Three-phase 200 to 240V-50/60Hz
: Single-phase 200 to 240V-50/60Hz
500V class : Three-phase 380 to 500V-50/60Hz
* Single-phase inputs are R/L1 and S/L2/N terminals.
Connect to three-phase motor.
Connect to braking resistors.
Change parameters , , ,  if necessary.
This is a positive potential terminal in the internal DC main circuit.
DC common power can be input between PA/- terminal and PC/- terminal.
This is a negative potential terminal in the internal DC main circuit.
DC common power can be input between PC/- terminal and PA/+ terminal.
Terminals for connecting a DC reactor (DCL: optional external device). Shorted by a
Shorting-bar when shipped from the factory. Before installing DCL, remove the
shorting- bar.
Inverter
U/T1
R/L1
S/L2
V/T2
W/T3
T/L3
PA/+
PB
Braking resistor
Terminal function
B-6
E6581611
Motor
M
Zero-phase
reactor