Mpls L2Vpn Configuration Examples; Configuring A Static Pw - HP 6127xlg Configuration Manual

MPLS L2VPN configuration examples

Configuring a static PW

Network requirements
Create a static PW between PE 1 and PE 2 over the backbone so that CE 1 and CE 2 can communicate
within VLAN 10.
Figure 87 Network diagram
Table 29 Interface and IP address assignment
Device
PE 1
PE 2
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs.
1. Configure CE 1.
<CE1> system-view
[CE1] interface fortygige 1/1/1
[CE1-FortyGigE1/1/1] port link-type trunk
[CE1-FortyGigE1/1/1] port trunk permit vlan 10
[CE1-FortyGigE1/1/1] quit
2. Configure PE 1:
# Configure an LSR ID.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
Interface IP address
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Loop0 192.3.3.3/32
Vlan-int30 10.2.2.1/24
Device Interface
P Loop0
Vlan-int30
Vlan-int20
339
IP address
192.4.4.4/32
10.2.2.2/24
10.1.1.2/24