HP 6127xlg Configuration Manual page 484

# Enable OSPFv3 on VLAN-interface 30.
[MCE] interface vlan-interface 30
[MCE-Vlan-interface30] ospfv3 10 area 0.0.0.0
[MCE-Vlan-interface30] quit
# On PE 1, enable OSPFv3 process 10 and bind the process to VPN instance vpn1.
[PE1] ospfv3 10 vpn-instance vpn1
[PE1-ospfv3-10] router-id 100.100.10.1
[PE1-ospfv3-10] quit
# Enable OSPFv3 on VLAN-interface 30.
[PE1] interface vlan-interface 30
[PE1-Vlan-interface30] ospfv3 10 area 0.0.0.0
[PE1-Vlan-interface30] quit
# Use similar procedures to configure OSPFv3 process 20 between the MCE and PE 1 and
redistribute VPN 2's routes from RIPng process 20 into the OSPFv3 routing table of the MCE.
(Details not shown.)
Verifying the configuration
# Display the routing table for VPN instance vpn1. The output shows that PE 1 has learned the private
route of VPN 1 through OSPFv3.
[PE1] display ipv6 routing-table vpn-instance vpn1
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop
Interface
Destination: 30::/64
NextHop
Interface
Destination: 30::2/128
NextHop
Interface
Destination: 2012:1::/64
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
# Display the routing table for VPN instance vpn2. The output shows that PE 1 has learned the private
route of VPN 2 through OSPFv3.
: ::1
: InLoop0
: ::
: Vlan30
: ::1
: InLoop0
: FE80::202:FF:FE02:2
: Vlan30
: ::
: NULL0
: ::
: NULL0
475
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : OSPFv3
Preference: 150
Cost : 1
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0