Ldp-Igp Synchronization - HP 6127xlg Configuration Manual

LDP-IGP synchronization

Basic operating mechanism
LDP establishes LSPs based on the IGP optimal route. If LDP is not synchronized with IGP, MPLS traffic
forwarding might be interrupted.
LDP is not synchronized with IGP when one of the following occurs:
A link is up, and IGP advertises and uses this link. However, LDP LSPs on this link have not been
•
established.
An LDP session on a link is down, and LDP LSPs on the link have been removed. However, IGP still
•
uses this link.
The Ordered label distribution control mode is used. IGP used the link before the local device
•
received the label mappings from the downstream LSR to establish LDP LSPs.
After LDP-IGP synchronization is enabled, IGP advertises the actual cost of a link only when LDP
convergence on the link is completed. Before LDP convergence is completed, IGP advertises the
maximum cost of the link. In this way, the link is visible on the IGP topology, but IGP does not select this
link as the optimal route when other links are available. Therefore, the device can avoid discarding MPLS
packets when there is not an LDP LSP established on the optimal route.
LDP convergence on a link is completed when all the followings occur:
The local device establishes an LDP session to at least one peer, and the LDP session is already in
•
Operational state.
The local device has distributed the label mappings to at least one peer.
•
Notification delay for LDP convergence completion
By default, LDP immediately sends a notification to IGP that LDP convergence has completed. However,
immediate notifications might cause MPLS traffic forwarding interruptions in one of the following
scenarios:
LDP peers use the Ordered label distribution control mode. The device has not received a label
•
mapping from downstream at the time LDP notifies IGP that LDP convergence has completed.
• A large number of label mappings are distributed from downstream. Label advertisement is not
completed when LDP notifies IGP that LDP convergence has completed.
To avoid traffic forwarding interruptions in these scenarios, configure the notification delay. When LDP
convergence on a link is completed, LDP waits before notifying IGP.
Notification delay for LDP restart or active/standby switchover
When an LDP restart or an active/standby switchover occurs, LDP takes time to converge, and LDP
notifies IGP of the LDP-IGP synchronization status as follows:
If a notification delay is not configured, LDP immediately notifies IGP of the current synchronization
•
states during convergence, and then updates the states after LDP convergence. This could impact
IGP processing.
• If a notification delay is configured, LDP notifies IGP of the LDP-IGP synchronization states in bulk
when one of the following events occurs:
LDP recovers to the state before the restart or switchover.
The maximum delay timer expires.
22