Configuring Ldp Pw Redundancy - HP 6127xlg Configuration Manual

[PE2-Ten-GigabitEthernet1/0/1-srv10] quit
[PE2-Ten-GigabitEthernet1/0/1] quit
# Create a cross-connect group named ccc, and create a remote CCC connection that has
incoming label 202, outgoing label 102, and next hop 10.2.2.2.
[PE2] xconnect-group ccc
[PE2-xcg-ccc] connection ccc
[PE2-xcg-ccc-ccc] ccc in-label 202 out-label 102 nexthop 10.2.2.2
# Bind Ethernet service instance 10 on Ten-GigabitEthernet 1/0/1 to the CCC connection.
[PE2-xcg-ccc-ccc] ac interface ten-gigabitethernet 1/0/1 service-instance 10
[PE2-xcg-ccc-ccc] quit
[PE2-xcg-ccc] quit
5. Configure CE 2.
<CE2> system-view
[CE2] interface fortygige 1/1/1
[CE2-FortyGigE1/1/1] port link-type trunk
[CE2-FortyGigE1/1/1] port trunk permit vlan 10
[CE2-FortyGigE1/1/1] quit
Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a remote CCC connection (identified by
PW ID/Rmt Site "-" and Proto Static) has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: ccc
Peer
10.1.1.2
# Display L2VPN PW information on PE 2. The output shows that a remote CCC connection has been
established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: ccc
Peer
10.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring LDP PW redundancy

Network requirements
Create two LDP PWs to implement PW redundancy between CE 1 and CE 2. The primary PW goes
through PE 1—PE 2. The backup PW goes through PE 1—PE 3. When the primary PW fails, CE 1 and
CE 2 communicate through the backup PW.
PW ID/Rmt Site In/Out Label
- 101/201
PW ID/Rmt Site In/Out Label
- 202/102
Proto
Static
Proto
Static
354
Flag Link ID State
M 0 Up
Flag Link ID State
M 0 Up