HP 6127xlg Configuration Manual page 253

Device
CE 3
CE 5
PE 1
PE 3
Configuration procedure
1. Configure MPLS L3VPN on the service provider backbone. Enable IS-IS, enable LDP, and establish
an MP-IBGP peer relationship between PE 1 and PE 2:
# Configure PE 1.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 3.3.3.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 3.3.3.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] isis 1
[PE1-isis-1] network-entity 10.0000.0000.0000.0004.00
[PE1-isis-1] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface vlan-interface 2
[PE1-Vlan-interface2] ip address 30.1.1.1 24
[PE1-Vlan-interface2] isis enable 1
[PE1-Vlan-interface2] mpls enable
[PE1-Vlan-interface2] mpls ldp enable
[PE1-Vlan-interface2] quit
[PE1] bgp 100
[PE1-bgp] peer 4.4.4.9 as-number 100
[PE1-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp] address-family vpnv4
[PE1-bgp-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-vpnv4] quit
[PE1-bgp] quit
# Configure PE 2 in the same way that PE 1 is configured. (Details not shown.)
# On PE 1 or PE 2, execute the following commands:
Interface IP address
Vlan-int1 100.1.1.1/24
Vlan-int3 110.1.1.1/24
Loop0 3.3.3.9/32
Vlan-int1 11.1.1.2/24
Vlan-int2 30.1.1.1/24
Loop0 1.1.1.9/32
Vlan-int1 100.1.1.2/24
Vlan-int2 10.1.1.1/24
Vlan-int3 110.1.1.2/24
Device Interface
CE 4 Vlan-int1
CE 6 Vlan-int3
PE 2 Loop0
Vlan-int1
Vlan-int2
PE 4 Loop0
Vlan-int1
Vlan-int2
Vlan-int3
244
IP address
120.1.1.1/24
130.1.1.1/24
4.4.4.9/32
21.1.1.1/24
30.1.1.2/24
6.6.6.9/32
120.1.1.2/24
20.1.1.2/24
130.1.1.2/24