HP 6127xlg Configuration Manual page 104

Figure 29 Network diagram
Table 4 Interface and IP address assignment
Device
Switch A
Switch B
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure OSPF to advertise routes within the ASs, and redistribute the direct and BGP routes into
OSPF on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ospf
[SwitchB-ospf-1] import-route direct
[SwitchB-ospf-1] import-route bgp
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
Device Interface
Switch D Loop0
Vlan-int3
Switch C Loop0
Vlan-int3
Vlan-int2
95
IP address
4.4.4.9/32
30.1.1.2/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24