HP 6127xlg Configuration Manual page 211

Method 1—Execute the pic command in BGP-VPN IPv4 unicast address family view. The device
•
calculates a backup next hop for each BGP route in the VPN instance if there are two or more
unequal-cost routes to reach the destination.
• Method 2—Execute the fast-reroute route-policy command in BGP-VPN IPv4 unicast address family
view to reference a routing policy in which a backup next hop is specified by using the apply
fast-reroute backup-nexthop command. The backup next hop calculated by the device must be the
same as the specified backup next hop. Otherwise, the device does not generate a backup next
hop for the primary route. You can also configure if-match clauses in the routing policy to identify
the routes protected by FRR.
If both methods are configured, Method 2 takes precedence over Method 1.
To configure MPLS L3VPN FRR:
Step
1. Enter system view.
2. Enable MPLS BFD.
3. Configure the source IP
address for BFD echo
packets.
4. Use BFD to test the
connectivity of an LSP or
MPLS TE tunnel.
Command
system-view
mpls bfd enable
bfd echo-source-ip ip-address
•
Configure BFD to test the
connectivity of the LSP for the
specified FEC:
mpls bfd dest-addr mask-length
[ nexthop nexthop-address
[ discriminator local local-id
remote remote-id ] ] [ template
template-name ]
•
Configure BFD to test the
connectivity of the MPLS TE tunnel
for the tunnel interface:
a. interface tunnel number
mode mpls-te
b. mpls bfd [ discriminator
local local-id remote
remote-id ] [ template
template-name ]
c. quit
202
Remarks
N/A
The mpls bfd enable command
applies to VPNv4 route backup for a
VPNv4 route and IPv4 route backup
for a VPNv4 route. For more
information about this command,
see MPLS Command Reference.
The bfd echo-source-ip command is
required when echo-mode BFD is
used to detect primary route
connectivity in VPNv4 route backup
for an IPv4 route. For more
information about this command,
see High Availability Command
Reference.
By default, BFD is not configured to
test the connectivity of the LSP or
MPLS TE tunnel.
This step is required for VPNv4 route
backup for a VPNv4 route and IPv4
route backup for a VPNv4 route.
Use either command depending on
the public tunnel type.
For more information about the
commands in this step, see MPLS
Command Reference.