Configuring A Label Advertisement Policy - HP 6127xlg Configuration Manual

Step
2. Enter LDP view or enter
LDP-VPN instance view.
3. Configure the label
distribution control
mode.

Configuring a label advertisement policy

A label advertisement policy uses IP prefix lists to control the FEC-label mappings advertised to peers.
As shown in
advertises label mappings for FECs permitted by IP prefix list C to LSR C.
Figure 15 Label advertisement control diagram
A label advertisement policy on an LSR and a label acceptance policy on its upstream LSR can achieve
the same purpose. HP recommends that you use label advertisement policies to reduce network load if
downstream LSRs support label advertisement control.
Before you configure an LDP label advertisement policy, create an IP prefix list. For information about IP
prefix list configuration, see Layer 3—IP Routing Configuration Guide.
To configure a label advertisement policy:
Step
1. Enter system view.
Command
•
Enter LDP view:
mpls ldp
•
Enter LDP-VPN instance view:
label-distribution { independent |
ordered }
Figure 15, LSR A advertises label mappings for FECs permitted by IP prefix list B to LSR B and
Command
system-view
a. mpls ldp
b. vpn-instance vpn-instance-name
29
Remarks
N/A
By default, the Ordered label
distribution mode is used.
To apply the new setting to LDP
sessions established before the
command is configured, you must
reset the LDP sessions.
Remarks
N/A