HP 6127xlg Configuration Manual page 163

<SwitchC> system-view
[SwitchC] mpls lsr-id 3.3.3.9
[SwitchC] mpls te
[SwitchC-te] quit
[SwitchC] rsvp
[SwitchC-rsvp] quit
[SwitchC] interface vlan-interface 2
[SwitchC-Vlan-interface2] mpls enable
[SwitchC-Vlan-interface2] mpls te enable
[SwitchC-Vlan-interface2] rsvp enable
[SwitchC-Vlan-interface2] rsvp hello enable
[SwitchC-Vlan-interface2] quit
4. Configure an MPLS TE tunnel. (Details not shown.)
5. Configure RSVP GR:
# Configure Switch A.
[SwitchA] rsvp
[SwitchA-rsvp] graceful-restart enable
# Configure Switch B.
[SwitchB] rsvp
[SwitchB-rsvp] graceful-restart enable
# Configure Switch C.
[SwitchC] rsvp
[SwitchC-rsvp] graceful-restart enable
Verifying the configuration
# After a tunnel is established from Switch A and Switch C, execute the following command on Switch A:
<SwitchA> display rsvp peer verbose
Peer: 10.1.1.2
Hello state: Up
PSB count: 0
Src instance: 0x1f08
Refresh reduction: Disabled
Peer GR restart time: 120000 ms
The output shows that the neighbor's GR state is Ready.
Interface: Vlan1
Hello type: Active
RSB count: 1
Dst instance: 0x22
Graceful Restart state: Ready
Peer GR recovery time: 0 ms
154