HP 6127xlg Configuration Manual page 448

instances can isolate routes of different VPNs. For more information about RIP, see Layer 3—IP Routing
Configuration Guide.
To configure RIP between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIP process for a
VPN instance and enter RIP
view.
3. Enable RIP on the interface
attached to the specified
network.
4. Redistribute remote site routes
advertised by the PE into RIP.
5. (Optional.) Configure the
default cost value for the
redistributed routes.
Configuring OSPF between an MCE and a VPN site
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF process
without binding it to a VPN instance, the process belongs to the public network.
Binding OSPF processes to VPN instances can isolate routes of different VPNs. For more information
about OSPF, see Layer 3—IP Routing Configuration Guide.
To configure OSPF between an MCE and a VPN site:
Step
1. Enter system view.
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name |
tag tag ] *
default cost value
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
439
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, create a
common RIP process.
By default, RIP is disabled on an
interface.
By default, no route is redistributed
into RIP.
The default cost is 0.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, create a
common OSPF process.
An OSPF process bound to a VPN
instance does not use the public
network router ID configured in
system view. Therefore, configure
a router ID for the OSPF process.
An OSPF process can belong to
only one VPN instance, but one
VPN instance can use multiple
OSPF processes to advertise VPN
routes.