Enabling Mpls Te - HP 6127xlg Configuration Manual

Tasks at a glance
(Required.)
(Required.)
(Optional.)
(Required.) Perform at least one of the following tasks to configure an MPLS TE tunnel:
•
Configuring an MPLS TE tunnel to use a static CRLSP
•
Configuring an MPLS TE tunnel to use a dynamic CRLSP
(Required.)
•
Configuring static routing to direct traffic to an MPLS TE tunnel
•
Configuring automatic route advertisement to direct traffic to an MPLS TE tunnel
(Optional.)
(Optional.)
Only MPLS TE tunnels established by RSVP-TE support this configuration.
(Optional.)
Only MPLS TE tunnels established by RSVP-TE support this configuration.

Enabling MPLS TE

Enable MPLS TE on each node and interface that the MPLS TE tunnel traverses.
Before you enable MPLS TE, complete the following tasks:
Configure static routing or IGP to make sure all LSRs can reach each other.
•
• Enable MPLS. For information about enabling MPLS, see
To enable MPLS TE:
Step
1. Enter system view.
2. Enable MPLS TE and enter MPLS
TE view.
3. Return to system view.
4. Enter interface view.
5. Enable MPLS TE for the
interface.
Enabling MPLS TE
Configuring a tunnel interface
Configuring DS-TE
Configuring traffic forwarding:
Configuring a bidirectional MPLS TE tunnel
Configuring CRLSP backup
Configuring MPLS TE FRR
Command
system-view
mpls te
quit
interface interface-type
interface-number
mpls te enable
63
"Configuring basic MPLS."
Remarks
N/A
By default, MPLS TE is disabled.
N/A
N/A
By default, MPLS TE is disabled
on an interface.