Displaying Static Lsps; Static Lsp Configuration Example; Network Requirements - HP 6127xlg Configuration Manual

Step
2. Configure the
ingress node of the
static LSP.
3. Configure the
transit node of the
static LSP.
4. Configure the
egress node of the
static LSP.

Displaying static LSPs

Execute display commands in any view.
Task
Display static LSP information.

Static LSP configuration example

Network requirements

Switch A, Switch B, and Switch C all support MPLS.
Establish static LSPs between Switch A and Switch C, so that subnets 1 1.1.1.0/24 and 21.1.1.0/24 can
access each other over MPLS.
Figure 8 Network diagram
Vlan-int4
11.1.1.1/24
11.1.1.0/24
Command
static-lsp ingress lsp-name destination
dest-addr { mask | mask-length } { nexthop
next-hop-addr | outgoing-interface
interface-type interface-number } out-label
out-label
static-lsp transit lsp-name in-label in-label
{ nexthop next-hop-addr |
outgoing-interface interface-type
interface-number } out-label out-label
static-lsp egress lsp-name in-label in-label
Command
display mpls static-lsp [ lsp-name lsp-name ]
Loop0
1.1.1.9/32
Vlan-int2
10.1.1.1/24
Vlan-int2
10.1.1.2/24
Switch A
Loop0
2.2.2.9/32
Vlan-int3
20.1.1.2/24
Vlan-int3
20.1.1.1/24
Switch B
13
Remarks
If you specify a next hop for the
static LSP, make sure the ingress
node has an active route to the
specified next hop address.
If you specify a next hop for the
static LSP, make sure the transit
node has an active route to the
specified next hop address.
You do not need to configure this
command if the outgoing label
configured on the penultimate hop
of the static LSP is 0 or 3.
Loop0
3.3.3.9/32
Vlan-int5
21.1.1.1/24
Switch C
21.1.1.0/24