Configuring Upe Dual Homing; Configuring Static Pw Redundancy - HP 6127xlg Configuration Manual

Configuring UPE dual homing

This task includes the following configurations:
• Create a backup PW for the primary PW.
Specify whether to switch traffic from the backup PW to the primary PW when the primary PW
•
recovers, and the wait time for the switchover.
Perform a manual PW switchover.
•

Configuring static PW redundancy

Step
1. Enter system view.
2. Enter VSI view.
3. Specify static signaling for
PWs, and enter VSI static view.
4. (Optional.) Specify whether to
switch traffic from the backup
PW to the primary PW when
the primary PW recovers, and
the wait time for the
switchover.
5. Configure a static PW and
enter VSI static PW view.
6. Configure a backup static PW
and enter VSI static backup
PW view.
7. Return to user view.
8. Manually switch traffic of the
specified PW to its backup
PW.
Command
system-view
vsi vsi-name
pwsignaling static
revertive { wtr wtr-time | never }
peer ip-address [ pw-id pw-id ]
[ in-label label-value out-label
label-value ] [ no-split-horizon |
pw-class class-name | tunnel-policy
tunnel-policy-name ] *
backup-peer ip-address [ pw-id
pw-id ] in-label label-value out-label
label-value [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
return
l2vpn switchover peer ip-address
pw-id pw-id
385
Remarks
N/A
N/A
By default, no PW signaling
protocol is specified for the VSI.
By default, when the primary PW
recovers, traffic is immediately
switched back from the backup
PW to the primary PW.
By default, no static PW is
configured.
By default, no backup static PW
is configured.
If both a default PW ID in the
default-pw-id command and a
PW ID in the backup-peer
command are configured, the
PW ID in the backup-peer
command is used. If only a
default PW ID is configured, the
default PW ID is used. If no
default PW ID is configured, you
must provide a PW ID in the
backup-peer command.
N/A
N/A