HP 6127xlg Configuration Manual page 455

Step
8. (Optional.) Configure OSPF
to redistribute the default
route.
9. (Optional.) Configure filtering
of advertised routes.
10. (Optional.) Configure the
default parameters for
redistributed routes (cost,
route number, tag, and type).
11. Create an OSPF area and
enter OSPF area view.
12. Enable OSPF on the interface
attached to the specified
network in the area.
Configuring IS-IS between an MCE and a PE
Step
1. Enter system view.
2. Create an IS-IS process
for a VPN instance and
enter IS-IS view.
3. Configure a network
entity title.
4. Redistribute VPN routes.
5. (Optional.) Configure
filtering of advertised
routes.
6. Return to system view.
7. Enter interface view.
8. Enable the IS-IS process
on the interface.
Command
default-route-advertise summary
cost cost
filter-policy { acl-number |
prefix-list prefix-list-name } export
[ protocol [ process-id ] ]
default { cost cost | tag tag | type
type } *
area area-id
network ip-address wildcard-mask
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
import-route protocol [ process-id |
all-processes | allow-ibgp ] [ cost cost |
cost-type { external | internal } | [ level-1
| level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
filter-policy { acl-number | prefix-list
prefix-list-name | route-policy
route-policy-name } export [ protocol
[ process-id ] ]
quit
interface interface-type interface-number
isis enable [ process-id ]
446
Remarks
By default, OSPF does not
redistribute the default route.
This command redistributes the
default route in a Type-3 LSA. The
MCE advertises the default route to
the PE.
By default, redistributed routes are
not filtered.
The default cost is 1, the default tag
is 1, and default type of
redistributed routes is Type-2.
By default, no OSPF area is
created.
By default, an interface neither
belongs to any area nor runs
OSPF.
Remarks
N/A
N/A
By default, no NET is configured.
By default, IS-IS does not
redistribute routes from any other
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table by default.
By default, IS-IS does not filter
advertised routes.
N/A
N/A
By default, no IS-IS process is
enabled.