Configuring Hello Parameters - HP 6127xlg Configuration Manual

Step
2. Enter interface view.
3. Enable LDP on the interface.

Configuring Hello parameters

Perform this task to configure the following hello timers:
Link Hello hold time and Link Hello interval.
•
Targeted Hello hold time and Targeted Hello interval for a specific peer.
•
Configuring Link Hello timers
Step
1. Enter system view.
2. Enter the view of the interface
where you want to establish
an LDP session.
Configure the Link Hello hold
3.
time.
4. Configure the Link Hello
interval.
Configuring Targeted Hello timers for an LDP peer
Step
1. Enter system view.
2. Enter LDP view.
3. Specify an LDP peer and enter
LDP peer view. The device will
send unsolicited Targeted
Hellos to the peer and can
respond to the Targeted Hellos
sent from the peer.
4. Configure the Targeted Hello
hold time.
5. Configure the Target Hello
interval.
Command
interface interface-type interface-number
mpls ldp enable
Command
system-view
interface interface-type
interface-number
mpls ldp timer hello-hold timeout
mpls ldp timer hello-interval
interval
Command
system-view
mpls ldp
targeted-peer peer-lsr-id
mpls ldp timer hello-hold timeout
mpls ldp timer hello-interval
interval
25
Remarks
If the interface is bound to a
VPN instance, you must
enable LDP for the VPN
instance by using the
vpn-instance command in
LDP view.
By default, LDP is disabled
on an interface.
Remarks
N/A
N/A
By default, the Link Hello hold time
is 15 seconds.
By default, the Link Hello interval is
five seconds.
Remarks
N/A
N/A
By default, the device does not
send Targeted Hellos to or
receive Targeted Hellos from
any peer.
By default, the Targeted Hello
hold time is 45 seconds.
By default, the Targeted Hello
interval is 15 seconds.