H-Vpls Using Access Configuration Example - HP 6127xlg Configuration Manual

PW State: Up
PW Status Communication: Notification method
PW ID FEC (Local/Remote):
Local AII
Remote AII
PW Type
Group ID
Label
Control Word: Disabled/Disabled
VCCV CV Type: -/-
VCCV CC Type: -/-
MTU
PW Status

H-VPLS using access configuration example

Network requirements
Configure an H-VPLS network using MPLS access to avoid full-mesh PW configuration. The H-VPLS uses
LDP as the PW signaling protocol.
Figure 103 Network diagram
Configuration procedure
1. Configure an IGP and public tunnels on each PE. (Details not shown.)
2. Configure UPE:
# Configure basic MPLS.
<UPE> system-view
[UPE] interface loopback 0
[UPE-LoopBack0] ip address 1.1.1.9 32
[UPE-LoopBack0] quit
[UPE] mpls lsr-id 1.1.1.9
[UPE] mpls ldp
: (1.1.1.9, 3.3.3.9)
: (3.3.3.9, 1.1.1.9)
: VLAN/VLAN
: 0/0
: 131154/131116
: 1500/1500
: PW forwarding/PW forwarding
404