HP 6127xlg Configuration Manual page 194

Step
2. Configure a static route
for a VPN instance.
Configuring RIP between a PE and a CE
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process without
binding it to a VPN instance, the process belongs to the public network.
To configure RIP between a PE and a CE:
Step
1. Enter system view.
2. Create a RIP process for a
VPN instance and enter RIP
view.
3. Enable RIP on the interface
attached to the specified
network.
Configuring OSPF between a PE and a CE
An OSPF process that is bound to a VPN instance does not use the public network router ID configured
in system view. Therefore, you must specify a router ID when starting a process or configure an IP address
for at least one interface of the VPN instance.
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF process
without binding it to a VPN instance, the process belongs to the public network.
To configure OSPF between a PE and a CE:
Step
1. Enter system view.
2. Create an OSPF process for a
VPN instance and enter the
OSPF view.
Command
ip route-static vpn-instance
s-vpn-instance-name dest-address { mask-length
| mask } { interface-type interface-number
[ next-hop-address ] |next-hop-address
[ public ] [ track track-entry-number ] |
vpn-instance d-vpn-instance-name
next-hop-address [ track track-entry-number ] }
[ permanent ] [ preference preference-value ]
[ tag tag-value ] [ description description-text ]
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
185
Remarks
By default, no static route is
configured for a VPN
instance.
Perform this configuration on
the PE. On the CE, configure
a common static route.
For more information about
static routing, see Layer 3—IP
Routing Configuration Guide.
Remarks
N/A
Perform this configuration on the
PE. On the CE, create a common
RIP process.
By default, RIP is disabled on an
interface.
Remarks
N/A
Perform this configuration on the
PE. On the CE, create a common
OSPF process.
Deleting a VPN instance also
deletes all related OSPF processes.