Configuring An Intra-Domain Multi-Segment Pw - HP 6127xlg Configuration Manual

Peer
1.1.1.1
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
# Manually switch to the backup PW on PE 1.
<PE1> l2vpn switchover peer 2.2.2.2 pw-id 20
# Display L2VPN PW information on PE 1. The output shows that the PW switchover is successful.
<PE1> display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 1 up, 1 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer
2.2.2.2
3.3.3.3
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring an intra-domain multi-segment PW

Network requirements
As shown in
between PE 1 and P, and an MPLS TE tunnel between P and PE 2.
Configure a multi-segment PW between PE 1 and PE 2, so CE 1 and CE 2 can communicate over the
backbone. The multi-segment PW includes an LDP PW between PE 1 and P, and a static PW between P
and PE 2. The two PWs are concatenated on P.
Figure 92 Network diagram
Table 34 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
PW ID In/Out Label
30 65779/65650
PW ID In/Out Label
20 65651/65779
30 65650/65779
Figure 92, there is no public tunnel between PE 1 and PE 2. There is an MPLS TE tunnel
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int23 23.1.1.1/24
Vlan-int10 100.1.1.2/24
Proto Flag
LDP M
Proto Flag
LDP M
LDP B
Device Interface
P Loop0
Vlan-int23
Vlan-int26
PE 2 Loop0
360
Link ID State
1 Up
Link ID State
1 Blocked
1 Up
IP address
192.4.4.4/32
23.1.1.2/24
26.2.2.2/24
192.3.3.3/32