Establishing An Mpls Te Tunnel With Rsvp-Te - HP 6127xlg Configuration Manual

Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: -
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each switch to
display static CRLSP information.
[SwitchA] display mpls lsp
FEC
1.1.1.1/0/1
2.1.1.2
[SwitchB] display mpls lsp
FEC
-
3.2.1.2
[SwitchC] display mpls lsp
FEC
-
[SwitchA] display mpls static-cr-lsp
Name
static-cr-lsp-1 Ingress
[SwitchB] display mpls static-cr-lsp
Name
static-cr-lsp-1 Transit
[SwitchC] display mpls static-cr-lsp
Name
static-cr-lsp1
# Execute the display ip routing-table command on Switch A. The output shows a static route entry with
interface Tunnel 0 as the output interface. (Details not shown.)

Establishing an MPLS TE tunnel with RSVP-TE

Network requirements
Switch A, Switch B, Switch C, and Switch D run IS-IS and all of them are Level-2 switches.
Use RSVP-TE to create an MPLS TE tunnel from Switch A to Switch D. The MPLS TE tunnel requires a
bandwidth of 2000 kbps.
The maximum bandwidth of the link that the tunnel traverses is 10000 kbps and the maximum reservable
bandwidth of the link is 5000 kbps.
: TE
: -
: -
: -
: -
: -
: 3
: -
: -
: -
: -
: -
Proto
StaticCR -/20
Local
Proto
StaticCR 20/30
Local
Proto
StaticCR 30/-
LSR Type In/Out Label
Null/20
LSR Type In/Out Label
20/30
LSR Type In/Out Label
Egress 30/Null
Record Label
Bandwidth Protection : -
Backup Bandwidth Type: -
Auto Created
Retry Interval
Reoptimization Freq
Backup LSP ID
Auto Bandwidth Freq
Max Bandwidth
In/Out Label Interface/Out NHLFE
Vlan1
-/- Vlan1
In/Out Label Interface/Out NHLFE
Vlan2
-/- Vlan2
In/Out Label Interface/Out NHLFE
-
Out Interface
Vlan1
Out Interface
Vlan2
Out Interface
-
88
: -
: -
: 2 sec
: -
: -
: -
: -
State
Up
State
Up
State
Up