Specifying A Dscp Value For Outgoing Rsvp Packets; Configuring Rsvp Gr - HP 6127xlg Configuration Manual

Step
6. Specify the maximum number
of out-of-sequence RSVP
authentication messages that
can be received on the
interface.
To configure RSVP authentication in RSVP view:
Step
1. Enter system view.
2. Enter RSVP view.
3. Enable RSVP authentication
globally and configure the
authentication key.
4. Enable challenge-response
handshake globally.
Configure the global idle
5.
timeout for RSVP security
associations.
6. Specify the global RSVP
authentication window
size—the maximum number
of RSVP authenticated
messages that can be
received out of sequence.

Specifying a DSCP value for outgoing RSVP packets

The DSCP value of an IP packet specifies the priority level of the packet and affects the transmission
priority of the packet.
To specify a DSCP value for outgoing RSVP packets:
Step
1. Enter system view.
2. Enter RSVP view.
3. Specify a DSCP value for
outgoing RSVP packets.

Configuring RSVP GR

RSVP GR depends on the RSVP hello extension function. When configuring RSVP GR, you must enable
RSVP hello extension.
Perform this task on GR-capable devices.
Command
rsvp authentication window-size
number
Command
system-view
rsvp
authentication key { cipher |
plain } auth-key
authentication challenge
authentication lifetime life-time
authentication window-size
number
Command
system-view
rsvp
dscp dscp-value
146
Remarks
By default, only one RSVP
authenticated message can be
received out of sequence.
Remarks
N/A
N/A
By default, RSVP authentication is
disabled.
By default, the challenge-response
handshake function is disabled.
By default, the idle timeout is 1800
seconds (30 minutes).
By default, only one RSVP
authenticated message can be
received out of sequence.
Remarks
N/A
N/A
By default, the DSCP value is 48.