Configuring An Ospfv3 Sham Link; Configuring A Loopback Interface; Redistributing The Loopback Interface Address; Creating A Sham Link - HP 6127xlg Configuration Manual

Configuring an OSPFv3 sham link

Before you configure an OSPFv3 sham link, configure basic IPv6 MPLS L3VPN (OSPFv3 is used between
PE and CE).

Configuring a loopback interface

Step
1. Enter system view.
2. Create a loopback interface
and enter loopback interface
view.
3. Associate the loopback
interface with a VPN instance.
4. Configure an IPv6 address for
the loopback interface.

Redistributing the loopback interface address

Step
1. Enter system view.
2. Enter BGP view.
3. Enter BGP-VPN instance
view.
4. Enter BGP-VPN IPv6 unicast
address family view.
5. Redistribute direct routes into
BGP (including the loopback
interface address).

Creating a sham link

Step
1. Enter system view.
2. Enter OSPFv3 view.
3. Enter OSPFv3 area view.
Command
system-view
interface loopback interface-number
ip binding vpn-instance
vpn-instance-name
See Layer 3—IP Services
Configuration Guide.
Command
system-view
bgp as-number
ip vpn-instance vpn-instance-name
address-family ipv6 [ unicast ]
import-route direct
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
area area-id
290
Remarks
N/A
By default, no loopback
interface is created.
By default, the interface is
associated with no VPN
instance.
By default, no IPv6 address is
configured for the loopback
interface.
Remarks
N/A
N/A
N/A
N/A
By default, no direct routes are
redistributed into BGP.
Remarks
N/A
N/A
N/A