Task
Display information about RSVP resource
reservation states.
Display information about RSVP path states.
Display RSVP statistics.
Clear RSVP security associations.
Clear RSVP statistics.
RSVP configuration examples
Establishing an MPLS TE tunnel with RSVP-TE
Network requirements
Switch A, Switch B, Switch C, and Switch D run IS-IS.
Use RSVP-TE to create an MPLS TE tunnel from Switch A to Switch D.
Figure 37 Network diagram
Table 10 Interface and IP address assignment
Device
Switch A
Switch B
Interface
IP address
Loop0
1.1.1.9/32
Vlan-int1
10.1.1.1/24
Loop0
2.2.2.9/32
Vlan-int1
10.1.1.2/24
Vlan-int2
20.1.1.1/24
Command
display rsvp reservation [ destination ip-address ] [ source
ip-address ] [ tunnel-id tunnel-id ] [ nexthop ip-address ]
[ verbose ]
display rsvp sender [ destination ip-address ] [ source
ip-address ] [ tunnel-id tunnel-id ] [ lsp-id lsp-id ] [ verbose ]
display rsvp statistics [ interface [ interface-type
interface-number ] ]
reset rsvp authentication [ from ip-address to ip-address ]
reset rsvp statistics [ interface [ interface-type
interface-number ]
Device
Interface
Switch D
Loop0
Vlan-int3
Switch C
Loop0
Vlan-int3
Vlan-int2
148
IP address
4.4.4.9/32
30.1.1.2/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24