HP 6127xlg Configuration Manual page 249

[PE3-bgp-ipv4-vpn1] peer 100.1.1.1 enable
[PE3-bgp-ipv4-vpn1] import-route direct
[PE3-bgp-ipv4-vpn1] quit
[PE3-bgp-vpn1] quit
[PE3-bgp] quit
# Configure PE 4 and CE 4 in the same way that PE 3 and CE 3 are configured. (Details not
shown.)
5. Configure MP-IBGP peer relationship between the PEs of the customer carrier to exchange the end
customers' VPN routes:
# Configure PE 3.
[PE3] bgp 100
[PE3-bgp] peer 6.6.6.9 as-number 100
[PE3-bgp] peer 6.6.6.9 connect-interface loopback 0
[PE3-bgp] address-family vpnv4
[PE3-bgp-vpnv4] peer 6.6.6.9 enable
[PE3-bgp-vpnv4] quit
[PE3-bgp] quit
# Configure PE 4 in the same way that PE 3 is configured. (Details not shown.)
Verifying the configuration
1. Display the public network routing table and VPN routing table on the provider carrier PEs, for
example, on PE 1:
# Verify that the public network routing table contains only routes of the provider carrier network.
[PE1] display ip routing-table
Destinations : 14
Destination/Mask
0.0.0.0/32
3.3.3.9/32
4.4.4.9/32
30.1.1.0/24
30.1.1.0/32
30.1.1.1/32
30.1.1.255/32
127.0.0.0/8
127.0.0.0/32
127.0.0.1/32
127.255.255.255/32
224.0.0.0/4
224.0.0.0/24
255.255.255.255/32
# Verify that the VPN routing table contains the internal routes of the customer carrier network, but
it does not contain the VPN routes that the customer carrier maintains on the PE.
[PE1] display ip routing-table vpn-instance vpn1
Destinations : 18
Routes : 14
Proto Pre Cost
Direct 0 0
Direct 0 0
ISIS 15 10
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 18
240
NextHop Interface
127.0.0.1 InLoop0
127.0.0.1 InLoop0
30.1.1.2 Vlan12
30.1.1.1 Vlan12
30.1.1.1 Vlan12
127.0.0.1 InLoop0
30.1.1.1 Vlan12
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
0.0.0.0 NULL0
0.0.0.0 NULL0
127.0.0.1 InLoop0