HP 6127xlg Configuration Manual page 372

# Create a cross-connect group named vpn1, create a cross-connect named svc in the group, and
bind Ethernet service instance 1000 on Ten-GigabitEthernet 1/0/1 to the cross-connect.
[PE2] xconnect-group vpn1
[PE2-xcg-vpn1] connection svc
[PE2-xcg-vpn1-svc] ac interface ten-gigabitethernet 1/0/1 service-instance 1000
# Create a static PW for the cross-connect to bind the AC to the PW.
[PE2-xcg-vpn1-svc] peer 192.4.4.4 pw-id 1000 in-label 200 out-label 100
[PE2-xcg-vpn1-svc-192.4.4.4-1000] quit
[PE2-xcg-vpn1-svc] quit
[PE2-xcg-vpn1] quit
5. Configure CE 2.
<CE2> system-view
[CE2] vlan 10
[CE2-vlan10] quit
[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
[CE2] interface fortygige 1/1/1
[CE2-FortyGigE1/1/1] port link-type trunk
[CE2-FortyGigE1/1/1] port trunk permit vlan 10
[CE2-FortyGigE1/1/1] quit
Verifying the configuration
# Display L2VPN PW information on P. The output shows that two PWs have been created to form a
multi-segment PW.
[P] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2, 2 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.2.2.2
192.3.3.3
# Display L2VPN PW information on PE 1. The output shows that a PW has been created.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
Peer
192.4.4.4
# Display L2VPN PW information on PE 2. The output shows that a PW has been created.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpn1
PW ID In/Out Label
1000 65779/65650
1000 100/200
PW ID In/Out Label
1000 65650/65779
Proto Flag
LDP M
Static M
Proto Flag
LDP M
363
Link ID State
0 Up
1 Up
Link ID State
1 Up