Setting Of System Event Log - NEC EXPRESSSCOPE Engine 3 User Manual

Setting of system event log

To move the current default target to /admin1/system1/log1, enter the following command at
the command prompt.
cd /admin1/system1/log1
The "Properties" section reported by the following command indicates the current setting of
system event log.
show
Enter the following command if you would like to modify a property of the setting of system
event log .
set <Property>=<New value>
The properties which the system event log target contains are as follows:
• oemnec_selbehavior
This specifies the behavior when the system event log repository is full. The valid
values for this property are followings. This is the dynamic setting.
0 : Stop logging the system event log. The system event log is not recorded any more
when the system event log is full.
1: Clear all system event logs. All system event logs are cleared when the system
event log is full.
2: Overwrite oldest system event log. Oldest system event log is overwritten with new
system event log when the system event log is full.
For example, enter the following command when you would like to enable the auto clear of
system event log.
set oemnec_selbehavior=1
The user must have an account as administrator for modifying the
setting of the system event log.
- -
41