Go/No-Go Determination I/O And External Start/Stop Input (Ext I/O) - YOKOGAWA DL850E User Manual

5.5 GO/NO-GO Determination I/O and External
Start/Stop Input (EXT I/O)
Connecting to Other Instruments
• Do not apply external voltage to the NO-GO OUT and GO OUT output pins. Doing so may
damage the instrument.
• When connecting the GO/NO-GO determination signal output to another device, do
not connect the wrong signal pin. Doing so may damage the DL850E/DL850EV or the
connected instrument.
• Do not connect a USB cable to the GO/NO-GO I/O connector. Doing so may damage the
instrument.
French
• Ne pas appliquer de tension externe aux broches de sortie NO-GO OUT et GO OUT. Cela
pourrait endommager le DL850E/DL850EV.
• Lors de la connexion de la sortie de signal de détermination GO/NO-GO à un autre
instrument, veiller à ne pas connecter les mauvaises broches de signal. Cela pourrait
endommager le DL850E/DL850EV ou l'instrument connecté.
• Ne pas brancher de câble USB sur le connecteur de sortie GO/NO-GO. Cela pourrait
endommager l'instrument.
About the External I/O Cable (720911; sold separately)
• Do not use the cable for anything other than the DL850E/DL850EV external I/O.
• Refer to the following figure to connect the cable to an external device.
Process the wires at the end of
the stripped cable as necessary.
Wire color
Red
Yellow
White
Green
Blue
5-6
Approx. 1.5 m
Pin no. Signal
1 EXT EVENT IN
2
START IN
3 GO OUT
4 NOGO OUT
5 GND
CAUTION
ATTENTION
RJ-11 connector
Logic
Negative logic
Negative logic
Negative logic
Negative logic
To the DL850E/DL850EV
6
1
IM DL850E-03EN