Connecting A Cable To The Can & Lin Bus Monitor Module - YOKOGAWA DL850E User Manual

3.16 Connecting a Cable to the CAN & LIN Bus
Monitor Module
To monitor CAN bus signals, connect a cable to the CAN bus monitor module's D-sub connector.
Connector Pinout
The pinout of the D-sub connector (9 pin, male) is shown below.
CAN bus signal input terminal
LIN bus signal input terminal
CAN bus signal input terminal
Pin No. Signal
1 (NC)
2 CAN_L
3 CAN_GND Ground
4 (NC)
5 (NC)
6 CAN_GND Ground
7 CAN_H
8 (NC)
9 (NC)
* One-inch screws (number 4-40 UNC) are used.
Note
The shell of the CAN bus signal input connector is connected to CAN_GND. The shell of the LIN bus signal
input connector is connected to LIN_GND. Additionally, CAN_GND and its connector shell and LIN_GND and
its connector shell are isolated from the electric potential of the DL850E/DL850EV case (earth).
Applying a voltage greater than the maximum input voltage may damage the input section.
French
Le fait d'appliquer une tension dépassant la tension d'entrée maximale risque d'endommager
la section d'entrée.
Connecting the Cable (Signal wires)
When you connect a cable to the D-sub connector, be sure to tighten the screws to ensure that the
cable is connected securely.
CAN & LIN bus monitor module
720241 (CAN & LIN)
IM DL850E-03EN
Pinout
5
1
Function
Not used (can not be connected to)
CAN low signal
Not used (can not be connected to)
Not used (can not be connected to)
CAN high signal
Not used (can not be connected to)
Not used (can not be connected to)
ATTENTION
Cable
Screws
9
6
LIN bus signal input terminal
Signal Function
LIN LIN signal
(NC) Not used (can not be connected to)
LIN_GND Ground
VBAT Battery supply voltage
(NC) Not used (can not be connected to)
LIN_GND Ground
(NC) Not used (can not be connected to)
(NC) Not used (can not be connected to)
(NC) Not used (can not be connected to)
CAUTION
1
2
3
4
5
6
App
Index
3-55