Connecting A Cable To The Can Bus Monitor Module - YOKOGAWA DL850E User Manual

3.15 Connecting a Cable to the CAN Bus Monitor
Module
To monitor CAN bus signals, connect a cable to the CAN bus monitor module's D-sub connector.
Connector Pinout
The pinout of the D-sub connector (9 pin, male) is shown below.
Pinout
5
1
Pin No.
1
2
3
4
5
6
7
8
9
* One-inch screws (number 4-40 UNC) are used.
Note
The connector shell is connected to GND. Additionally, GND and the connector shell are isolated from the
electric potential of the DL850E/DL850EV case (earth).
Applying a voltage greater than the maximum input voltage may damage the input section.
French
Le fait d'appliquer une tension dépassant la tension d'entrée maximale risque d'endommager
la section d'entrée.
Connecting the Cable (Signal wires)
When you connect a cable to the D-sub connector, be sure to tighten the screws to ensure that the
cable is connected securely.
CAN bus monitor module
720240 (CAN MONITOR)
3-54
9
6
Signal
(NC)
CAN_L
GND
(NC)
(NC)
GND
CAN_H
(NC)
(NC)
Cable
Screws
Function
Not used (can not be connected to)
CAN low signal
Ground
Not used (can not be connected to)
Not used (can not be connected to)
Ground
CAN high signal
Not used (can not be connected to)
Not used (can not be connected to)
CAUTION
ATTENTION
IM DL850E-03EN