YOKOGAWA DL850E User Manual page 150

External Start/Stop Input
Item
Connector type
Input level
COMP Output (Probe-compensation-signal output terminal)
Item
Output signal frequency
Output amplitude
Probe Power Output (/P4 Option)
Item
Number of output terminals
Output voltage
Output current
Time Sync Signal Input (IRIG; /C20 option)
Item
Input connector
Number of input connectors 1
Supported IRIG signals
Input impedance
Maximum input voltage
Used for
Clock sync range
Post-sync accuracy
GPS Interface (/C30 option)
Item
Input connector
Number of input connectors 1
Receiver type
Function
Accuracy after
1
synchronization
Sync time
Compatible antenna
1 The figure is based on results obtained when the GPS antenna is installed in a location with good line of sight to GPS
satellites. The accuracy may not be attained depending on the measurement location, the location of satellites when the
measurement is taken, the weather, and influence caused by obstruction.
IM DL850E-03EN
Specifications
RJ-11 modular jack
TTL or contact
Specifications
1 kHz ± 1%
1 Vp-p ± 10%
Specifications
4
±12 V
Up to 1 A
Specifications
BNC
A002, B002, A132, and B122
You can switch between 50 Ω and 5 kΩ.
±8 V
Synchronizing the DL850E/DL850EV time
Synchronizing the sample clock
±80 ppm
No drift from the input signal
Specifications
SMA
GPS L1 C/A code SBAS:WAAS EGNOS MSAS
DL850E/DL850EV time synchronization
Sample clock synchronization
± 200 ns (when locked to GPS signal)
Within 5 minutes after the power is turned on
Active antenna, 3.3 V power supply
A1058ER standard accessory
6.10 Auxiliary I/O Section
6-15
1
2
3
4
5
6
App
Index