Example For Configuring Tangent Rrpp Rings - Huawei Quidway S6700 series Configuration Manual

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability

3.6.3 Example for Configuring Tangent RRPP Rings

Networking Requirements
As shown in
RRPP function. Switch A, Switch B, and Switch C are on ring 2 of domain 2. Switch C, Switch
D, and Switch E are on ring 1 of domain 1. Switch C is the tangent point of the two rings.
Figure 3-7 Networking diagram of tangent RRPP rings
Configuration Roadmap
The configuration roadmap is as follows:
Issue 01 (2011-07-15)
#
rrpp domain 1
control-vlan 10
protected-vlan reference-instance 1
ring 1 node-mode transit primary-port XGigabitEthernet 0/0/2 secondary-port
XGigabitEthernet 0/0/1 level 0
ring 1 enable
ring 2 node-mode assistant-edge common-port XGigabitEthernet 0/0/2 edge-port
XGigabitEthernet 0/0/3
ring 2 enable
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
interface XGigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
interface XGigabitEthernet0/0/3
port link-type trunk
port trunk allow-pass vlan 2 to 11
stp disable
#
return
Figure 3-7, Switch A, Switch B, Switch C, Switch D, and Switch E support the
Domain 2
XGE0/0/2
SwitchB
XGE0/0/1
XGE0/0/2
SwitchA
XGE0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
XGE0/0/3
XGE0/0/2
SwitchC
Ring 2
XGE0/0/4
XGE0/0/1
3 RRPP Configuration
Domain 1
XGE0/0/1
SwitchE
XGE0/0/2
Ring 1
XGE0/0/1
SwitchD
88