Huawei Quidway S6700 series Configuration Manual page 185

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
[SwitchB-XGigabitEthernet0/0/1] efm error-frame-second notification enable
[SwitchB-XGigabitEthernet0/0/1] quit
Step 5 Verify the configuration.
# If EFM OAM is configured correctly on Switch A and Switch B, XGE 0/0/1 and XGE 0/0/1
start the handshake after negotiation. Run the display efm session command on Switch A or
Switch B, and you can find that the EFM OAM protocol is in detect state.
[SwitchB] display efm session interface gigabitethernet 0/0/1
Interface
--------------------------------------------------------------------
XGigabitEthernet0/0/1
# Run the display efm command on Switch B. If the function of detecting errored frames, errored
codes, and errored frame seconds on XGE 0/0/1 is configured corrected, the following
information is displayed:
[SwitchB] display efm interface xgigabitethernet 0/0/1
----End
Configuration Files
l
l
Issue 01 (2011-07-15)
Item
-------------------------------------
Interface:
EFM Enable Flag:
Mode:
OAMPDU MaxSize:
ErrCodeNotification:
ErrCodePeriod:
ErrCodeThreshold:
ErrFrameNotification:
ErrFramePeriod:
ErrFrameThreshold:
ErrFrameSecondNotification:
ErrFrameSecondPeriod:
ErrFrameSecondThreshold:
Hold Up Time:
ThresholdEvtTriggerErrDown:
TriggerIfDown:
TriggerMacRenew:
Remote MAC:
Remote EFM Enable Flag:
Remote Mode:
Remote MaxSize:
Remote State:
Configuration file of Switch A
#
sysname SwitchA
#
efm enable
#
interface XGigabitEthernet0/0/1
efm mode passive
efm enable
#
return
Configuration file of Switch B
#
sysname SwitchB
#
efm enable
#
interface XGigabitEthernet0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
EFM State
detect
Value
XGigabitEthernet0/0/1
enable
active
128
enable
5
5
enable
5
5
enable
120
5
10
enable
disable
disable
0010-0010-0010
enable
passive
128
--
4 Ethernet OAM Configuration-EFM
Loopback Timeout
--
175