Huawei Quidway S6700 series Configuration Manual page 133

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
l Run the display rrpp brief command on PE-AGG. The following information is displayed:
l Run the display rrpp verbose domain command on UPE B. You can obtain the following
Issue 01 (2011-07-15)
UPE B is a transit node on ring 1; XGE 0/0/1 is the primary port; XGE 0/0/2 is the secondary
port.
UPE B is an edge transit node on ring 2. XGE 0/0/1 is the public port and XGE 0/0/3 is the
edge port.
UPE B is an edge transit node on ring 3. XGE 0/0/1 is the public port and XGE 0/0/4 is the
edge port.
In domain 2:
VLAN 10 is the control VLAN and VLANs mapping instance 2 are the protected VLANs.
UPE B is a transit node on ring 1. XGE 0/0/1 is the primary port, and XGE 0/0/2 is the
secondary port.
UPE B is an edge transit node on ring 2. XGE 0/0/1 is the public port and XGE 0/0/3 is the
edge port.
UPE B is an edge transit node on ring 3. XGE 0/0/1 is the public port and XGE 0/0/4 is the
edge port.
[PE-AGG] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status:
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 1 sec(default is 0 sec)
Number of RRPP Domains: 2
Domain Index : 1
Control VLAN : major 5
Protected VLAN : Reference Instance 1
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
Enabled
-------------------------------------------------------------------------------
--
1 0 M
Domain Index : 2
Control VLAN : major 10
Protected VLAN: Reference Instance 2
Hello Timer : 1 sec(default is 1 sec)
Ring Ring Node
ID Level Mode
Enabled
-------------------------------------------------------------------------------
--
1 0 M
The preceding information shows that the RRPP protocol is enabled on PE-AGG, and the
link-Up timer is 2 seconds.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; PE-AGG is the master node on ring 1. XGE 0/0/1 is the primary port, and XGE
0/0/2 is the secondary port.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; PE-AGG is the master node on ring 1. XGE 0/0/2 is the primary port, and XGE
0/0/1 is the secondary port.
results:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Enable
sub 6
Fail Timer : 6 sec(default is 6 sec)
Primary/Common
Port
XGigabitEthernet0/0/1
sub 11
Fail Timer : 6 sec(default is 6 sec)
Primary/Common
Port
XGigabitEthernet0/0/2
3 RRPP Configuration
Secondary/Edge
Port
XGigabitEthernet0/0/2
Secondary/Edge
Port
XGigabitEthernet0/0/1
Is
Yes
Is
Yes
123