Huawei Quidway S6700 series Configuration Manual page 294

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
Figure 7-4 Networking diagram of a remote MAC swap loopback test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Create VLAN 100, configure XGE 0/0/1 as a trunk interface, and add XGE 0/0/1 to VLAN 100.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] vlan batch 100
[SwitchB] interface xgigabitethernet 0/0/1
[SwitchB-XGigabitEthernet0/0/1] port link-type trunk
[SwitchB-XGigabitEthernet0/0/1] port trunk allow-pass vlan 100
[SwitchB-XGigabitEthernet0/0/1] quit
Step 2 Configure remote MAC swap loopback and enable the MAC swap loopback function on XGE
0/0/1.
[SwitchB-XGigabitEthernet0/0/1] loopback remote swap-mac source-mac 0018-2000-0085
dest-mac 018-2000-0070 vlan 100 timeout 80
[SwitchB-XGigabitEthernet0/0/1] loopback swap-mac start
[SwitchB-XGigabitEthernet0/0/1] quit
Step 3 Verify the configuration.
Issue 01 (2011-07-15)
Tester
Ethernet
Create a VLAN, configure XGE 0/0/1 as a trunk interface, and add the interface to the
VLAN.
Configure remote MAC swap loopback on Switch B.
Enable the MAC swap loopback function on Switch B.
VLAN ID: 100
Source and destination MAC addresses of test Ethernet frames: 0018-2000-0085 and
0018-2000-0070
Timeout period of the loopback test: 80s
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
XGE0/0/1
SwitchB
7 MAC Swap Loopback Configuration
Users
284