Huawei Quidway S6700 series Configuration Manual page 50

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
XGigabitEthernet0/0/2
:00
# Run the undo shutdown command to enable XGE 0/0/1 and wait for 30 seconds. Then you
can find that XGE 0/0/1 is in Active state and XGE 0/0/2 is in Inactive state.
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] shutdown
[SwitchA-XGigabitEthernet0/0/1] display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
Wtr-time is: 30 sec.
Load-Balance Instance: 10
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494 Control-vlan ID:
10
----------------------------------------------------------------------
XGigabitEthernet0/0/1
:00
XGigabitEthernet0/0/2
:00
----End
Configuration Files
l
l
Issue 01 (2011-07-15)
Member
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 10 100 500
#
stp region-configuration
instance 10 vlan 10 100 500
active region-configuration
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10 100 500
stp disable
#
interface XGigabitEthernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10 100 500
stp disable
#
smart-link group 1
load-balance instance 10 slave
restore enable
smart-link enable
port XGigabitEthernet0/0/1 master
port XGigabitEthernet0/0/2 slave
timer wtr 30
flush send control-vlan 10 password simple 123
#
return
Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 10 100 500
#
interface XGigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10 100 500
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Smart Link and Monitor Link Configuration
Slave Active 1
Role State Flush Count Last-Flush-Time
Master Active 2
Slave Inactive 1
0000/00/00 00:00:00 UTC+00
0000/00/00 00:00:00 UTC+00
0000/00/00 00:00:00 UTC+00
40