Huawei Quidway S6700 series Configuration Manual page 45

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
<SwitchC> system-view
[SwitchC] interface xgigabitethernet 0/0/1
[SwitchC-XGigabitEthernet0/0/1] smart-link flush receive control-vlan 10 password
simple 123
[SwitchC-XGigabitEthernet0/0/1] quit
Step 7 Verify the configuration.
# Run the display smart-link group command to view information about the Smart Link group
on Switch A. If the following information is displayed, the configuration is successful.
l The Smart Link group is enabled.
l The control VLAN ID is 10.
l XGE 0/0/1 is the master interface and is in Active state, and XGE 0/0/2 is the slave interface
[SwitchA] display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
Wtr-time is: 30 sec.
There is no Load-Balance
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494 Control-vlan ID:
10
----------------------------------------------------------------------
XGigabitEthernet0/0/1
:00
XGigabitEthernet0/0/2
:00
# Run the shutdown command to shut down XGEt 0/0/1, and you can find that XGE 0/0/1 is in
Inactive state and XGE 0/0/2 is in Active state.
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] undo shutdown
[SwitchA-XGigabitEthernet0/0/1]display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
Wtr-time is: 30 sec.
There is no Load-Balance
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494
10
----------------------------------------------------------------------
XGigabitEthernet0/0/1
:00
XGigabitEthernet0/0/2
:00
# Run the undo shutdown command to shut down XGE 0/0/1, and you can find that XGE 0/0/1
is in Active state and XGE 0/0/2 is in Inactive state.
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] undo shutdown
[SwitchA-XGigabitEthernet0/0/1] display smart-link group 1
Smart Link group 1 information :
Smart Link group was enabled
There is no Load-Balance
There is no protected-vlan reference-instance
DeviceID: 0025-9e80-2494 Control-vlan ID:
10
----------------------------------------------------------------------
Issue 01 (2011-07-15)
and is in Inactive state.
Member
Member
Member
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Smart Link and Monitor Link Configuration
Role State Flush Count Last-Flush-Time
Master Active 1
Slave Inactive 0
Control-vlan ID:
Role State Flush Count Last-Flush-Time
Master Inactive 1
Slave Active 1
Role State Flush Count Last-Flush-Time
0000/00/00 00:00:00 UTC+00
0000/00/00 00:00:00 UTC+00
0000/00/00 00:00:00 UTC+00
0000/00/00 00:00:00 UTC+00
35