Huawei Quidway S6700 series Configuration Manual page 114

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
l # Configure UPE B.
# Enable the RRPP protocol.
[UPEB] rrpp enable
l Configure UPE C.
# Enable the RRPP protocol.
[UPEC] rrpp enable
l Configure PE-AGG.
# Enable the RRPP protocol.
[PE-AGG] rrpp enable
Step 6 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE A and PE-AGG are
used as examples.
l Run the display rrpp brief command on UPE A. The following information is displayed:
[UPEA] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 2
Domain Index
Control VLAN
Protected VLAN : Reference Instance 1
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
Domain Index
Control VLAN
Protected VLAN : Reference Instance 2
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
You can see that the RRPP protocol is enabled on UPE A.
In domain 1, VLAN 5 is the control VLAN; VLANs mapping instance 1 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is XGE 0/0/1, and the secondary
port is XGE 0/0/2.
In domain 2, VLAN 10 is the control VLAN; VLANs mapping instance 2 are the protected
VLANs; UPE A is a transit node on ring 1. The primary port is XGE 0/0/1, and the secondary
port is XGE 0/0/2.
l Run the display rrpp brief command on PE-AGG. The following information is displayed:
[PE-AGG] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
Issue 01 (2011-07-15)
: 1
: major 5
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 T XGigabitEthernet0/0/1
: 2
: major 10
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 T XGigabitEthernet0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
sub 6
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
XGigabitEthernet0/0/2
sub 11
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
XGigabitEthernet0/0/2
3 RRPP Configuration
Is
Enabled
Yes
Is
Enabled
Yes
104