Huawei Quidway S6700 series Configuration Manual page 151

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability
l Configure UPE D.
# Enable the RRPP protocol.
[UPED] rrpp enable
l Configure UPE E.
# Enable the RRPP protocol.
[UPEE] rrpp enable
l Configure UPE F.
# Enable the RRPP protocol.
[UPEF] rrpp enable
l Configure UPE G.
# Enable the RRPP protocol.
[UPEG] rrpp enable
Step 6 Verify the configuration.
After the preceding configurations are complete and the network topology becomes stable,
perform the following operations to verify the configuration. Here, UPE D is taken for example.
l Run the display rrpp brief command on UPE D. The following information is displayed:
[UPED] display rrpp brief
Abbreviations for Switch Node Mode :
M - Master , T - Transit , E - Edge , A - Assistant-Edge
RRPP Protocol Status: Enable
RRPP Working Mode: HW
RRPP Linkup Delay Timer: 0 sec (0 sec default).
Number of RRPP Domains: 3
Domain Index
Control VLAN
Protected VLAN : Reference Instance 1
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
Domain Index
Control VLAN
Protected VLAN : Reference Instance 2
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
Domain Index
Control VLAN
Protected VLAN : Reference Instance 1 to 3
Hello Timer
Ring
ID
----------------------------------------------------------------------------
1
The preceding information shows that the RRPP protocol is enabled on UPE D.
In domain 1:
Issue 01 (2011-07-15)
: 1
: major 5
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 M XGigabitEthernet0/0/1
: 2
: major 10
: 1 sec(default is 1 sec)
Ring Node Primary
Level Mode Port
0 M XGigabitEthernet0/0/2
: 3
: major 20
: 1 sec(default is 1 sec)
Ring Node Primary/Common
Level Mode Port
0 T XGigabitEthernet0/0/3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
sub 6
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
XGigabitEthernet0/0/2
sub 11
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
XGigabitEthernet0/0/1
sub 21
Fail Timer : 6 sec(default is 6 sec)
Secondary/Edge
Port
XGigabitEthernet0/0/4
3 RRPP Configuration
Is
Enabled
Yes
Is
Enabled
Yes
Is
Enabled
Yes
141