Example For Configuring A Single Rrpp Ring - Huawei Quidway S6700 series Configuration Manual

Quidway S6700 Series Ethernet Switches
Configuration Guide - Reliability

3.6.1 Example for Configuring a Single RRPP Ring

Networking Requirements
As shown in
A, Switch B, and Switch C are on ring 1 of RRPP domain 1. The data of VLANs 100 to 300
needs to be protected.
Figure 3-5 Networking diagram of a single RRPP ring
SwitchB
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Map instance 1 to VLANs 100 to 300.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] stp region-configuration
[SwitchA-mst-region] instance 1 vlan 20 21 100 to 300
[SwitchA-mst-region] active region-configuration
[SwitchA-mst-region] quit
Issue 01 (2011-07-15)
Figure 3-5, Switch A, Switch B, and Switch C support the RRPP function. Switch
XGE0/0/2
XGE0/0/1
XGE0/0/1
Ring 1
XGE0/0/2 XGE0/0/2
XGE0/0/1
Map instance 1 to VLANs 100 to 300.
Locate Switch A, Switch B, and Switch C on ring 1 of RRPP domain 1.
Configure Switch A as the master node on ring 1, and configure Switch B and Switch C as
transit nodes on ring 1.
Numbers of the RRPP interfaces
Control VLAN ID of ring 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchC
Primary Port
Secondary port
3 RRPP Configuration
74