System Configuration And Menu Options; Root Menus; Frequency Command Mode; Frequency Setting - Toshiba H9 ASD Installation And Operation Manual

System Configuration and Menu Options

Root Menus

The Mode key accesses the three primary modes of the H9 ASD: the Frequency Command mode, the
Monitor mode, and the Program mode. From either mode, press the Mode key to loop through to the
other two modes (see Figure 27). While in the Frequency Command mode, pressing the ESC key
toggles the menu to and from the EOI Command mode and the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen and on the LED screen when active. Fault
information will be displayed via the Fault screen. See Alarms and Trips on pg. 244 for more information
on Alarms and Trips.
Figure 27. H9 ASD Root Menu Navigation.

Frequency Command Mode

Frequency Setting

While operating in the Local mode (Local LED is illuminated on the EOI), the running frequency of the
motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the
Frequency Command value, connect ST to CC, and provide a Run command (F and/or R) and then
press the Run key. The motor will run at the Frequency Command speed and may be changed while
running. See Figure 22 on pg. 32 and Operation (Local) on pg. 73 for more information on the Frequency
Command mode.
H9 ASD Installation and Operation Manual 41
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net