EOI Remote Mounting Using the ASD-MTG-KIT9
SD-MTG-
IT9
EOI ASD-MTG-KIT9 Mounting Dimensions
H9 ASD Installation and Operation Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Note: See
Figure 26
for the dimensions and the item locations referenced in steps
1.
At the EOI mounting location, mark the 4.60" by 4.50" hole and the four 11/32" screw holes.
2.
Cut the 4.60" by 4.50" rectangular hole.
3.
Drill the four 11/32" holes for the Bezel Plate mount.
4.
Attach and secure the Bezel Plate to the front side of the mounting location using the four 10-32
hex nuts, #10 split lock washers, and the #10 flat washers.
5.
Attach and secure the EOI to the front side of the Bezel Plate using the four 6-32 x 5/16" pan head
screws, #6 split lock washers, and the #6 flat washers.
6.
Connect the extension cable.
Figure 26. EOI Bezel Plate Mounting Dimensions.
1
through 6.
35