Toshiba H9 ASD Installation And Operation Manual page 47

7 — Communication Option Board
Use this setting if using the optional Communication Board for frequency control.
8 — RX2 Option (AI1)
Used for a -10 to +10-volt DC analog input signal.
9 — Option V/I
Allows for the use of the optional voltage/current frequency-control interface.
10 — UP/DOWN Frequency
A discrete terminal may be configured to increase or decrease the speed of the motor by
11 — Pulse Input Option
Used to allow the system to use a pulsed input for frequency control. See
12 — Pulse Input (motor CPU)
Used to allow the system to use a pulsed input for frequency control. See
13 — Binary/BCD Input Option
Allows for the discrete terminals to be used for frequency-control input. Input may be provided
40
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
momentarily connecting the assigned discrete input terminal to CC. See
further information on this feature.
Setting on pg. 122 for further information on this feature.
Setting on pg. 122 for further information on this feature.
as binary or binary coded decimal.
F264 on pg. 128
PG Input Point 1
PG Input Point 1
H9 ASD Installation and Operation Manual
for